No quest in Arc Raiders has you dodging fire blasts and doing parkour like A Prime Specimen. This quest has you looting an Arc Deforester using two Arc Powercells while also trying to avoid getting burned by the inside of it.

There are a few different steps to this quest that can become confusing if you’re not sure exactly where to go. To make things easier for you, here’s a guide on completing the quest A Prime Specimen in Arc Raiders.

How to complete A Prime Specimen in Arc Raiders

First, you will need to find an Arc Deforester to start the quest A Prime Specimen in Arc Raiders. You can find quite a few of these gigantic husks of the once-alive Arcs around Blue Gate, the same map that the Bees! quest was on. Head to either of the three spots on the map above to get to the next step of this quest.

How to interact and loot an Arc Deforester

Now that you’ve found one, jump up into the main hull. Once inside, you should see an open panel to interact with. Make sure you’ve brought two Arc Powercells with you, as you’ll need one to interact with the panel.

After that, fire will start blasting out on the inside of the husk, but it’s in timed intervals. Wait until the coast is clear, then run further inside the husk before getting burned.

At the end of the husk is another panel you can interact with and use the second Arc Powercell. Do that, then run back to the front. You will need to make it up to the second level of this husk.

I found it easiest to climb up on the side and then jump into the middle to make it there. Once you’re up top, you will still need to time the fire. Wait until you’re safe from getting burnt, then run further inside and loot the Arc Deforester.

That’s all you needed to do to complete A Prime Specimen! Now, you can move on to other missions by reading our full Arc Raiders quest list.